Lit. No. 43573/43583/43593, Rev. 01 10 August 15, 2013
MOUNTING THE SPREADER
8. Once the spreader is positioned front to back,
center it left to right. Looking at the inside front
and rear corner of the lower frame area, you will
notice four holes in the bottom of the frame. Using
a paint pen or similar marking device, mark hole
locations.
9. Drill holes at the marked locations.
10. Install and tighten all four cap screws.
11. Install the four ratchet straps as shown below.
NOTE: It is important for safety that this strapping
method be used as the standard mounting
procedure.
12. Connect the spreader power cord to vehicle
main power plug mounted at the rear of the
vehicle (refer to installation instructions for wiring
instructions).
Cross left upper to
right lower
Strap from rear
of vehicle to front
corner (both sides)
Cross right upper to
left lower
Tarp Kit
Ratchet Strap
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
To Next Page
Loading...
