Lit. No. 43573/43583/43593, Rev. 01  5  August 15, 2013
SAFETY INFORMATION
SAFETY PRECAUTIONS
Improper installation and operation could cause 
personal injury and/or equipment and property damage. 
Read and understand labels and the Owner's Manual 
before installing, operating or making adjustments.
 WARNING
•  Driver to keep bystanders minimum of 
25 feet away from operating spreader.
•  Before working with the spreader, secure all 
loose-fi tting clothing and unrestrained hair.
•  Before operating the spreader, verify all 
safety guards are in place.
•  Before servicing the spreader, wait for 
conveyor and spinner to stop.
•  Do not climb into or ride on spreader.
 WARNING
Overloading could result in an accident or 
damage. Do not exceed GVWR or GAWR 
ratings as found on the driver-side door 
cornerpost of the vehicle. See Loading 
Section to determine maximum volumes of 
spreading material.
 WARNING
Do not install the control for this product in 
the deployment path of an air bag. Refer to 
vehicle manufacturer's manual for air bag 
deployment area(s).
 CAUTION
During the hopper spreader installation 
we recommend the addition of an OSHA 
compliant Backup Alarm. This alarm is 
required for OSHA governed employers.
 CAUTION
Disconnect electric and/or hydraulic power 
and tag out if required before servicing or 
performing maintenance.
 CAUTION
DO NOT leave unused material in hopper. 
Material can freeze or solidify, causing unit to 
not work properly. Empty and clean after each 
use.
NOTE: Lubricate grease fi ttings after each use. 
Use a good quality multipurpose grease.
PERSONAL SAFETY
•  Remove ignition key and put the vehicle in park or 
in gear to prevent others from starting the vehicle 
during installation or service.
•  Wear only snug-fi tting clothing while working on 
your vehicle or spreader.
•  Do not wear jewelry or a necktie, and secure long 
hair.
•  Wear safety goggles to protect your eyes from 
battery acid, gasoline, dirt and dust.
•  Avoid touching hot surfaces such as the engine, 
radiator, hoses and exhaust pipes.
•  Always have a fi re extinguisher rated BC handy, 
for fl ammable liquids and electrical fi res.
 CAUTION
•  Do not operate a spreader in need of 
maintenance.
•  Before operating the spreader, reassemble 
any parts or hardware removed for cleaning 
or adjusting.
•  Before operating the spreader, remove 
materials such as cleaning rags, brushes, 
and hand tools from the spreader.
•  While operating the spreader, use auxiliary 
warning lights, except when prohibited by law.