Lit. No. 43573/43583/43593, Rev. 01 12 August 15, 2013
WIRING AND HARNESS INSTRUCTIONS
NOTE: In the off season, remove control and
put in a cool, dry place. The interior summer
temperatures could damage circuit board and
void warranty.
NOTE: Do not modify harness length. Any
modifi cations will void warranty.
• All external connections must have dielectric
grease.
• Read lead labels before attaching to power source
or ground.
• No other devices may be spliced into wiring
harness.
• Any repairs to wiring harness must be done with
heat shrink butt connectors.
• If inline fuse is installed, use a 60 amp maxi fuse or
circuit breaker.
3. Push the ON/OFF switch on the control to check
for power. After power has been confi rmed,
push the ON/OFF switch again to turn OFF. The
electrical portion of the installation is complete.
NOTE: Use dielectric grease on all electrical
connections.
HARNESS DUST COVER
Install the dust cover as shown.
To Next Page
Loading...
