June 1, 2002 8 Lit. No. 94866/94867
WIRING INSTRUCTIONS
Vehicle Harness Installation
All spreaders are shipped from the factory with the
spreader harness wired to the engine, clutch, and
electric throttle.
NOTE: Use dielectric grease on all electrical
connections.
CAUTION
Before drilling any holes, check both sides of
the material for any wires, fuel lines, fuel tanks,
etc. that may be damaged by drilling.
Wiring Instructions
To properly wire the hopper spreader, please adhere to
the following recommended installation sequence.
1. Install either the Spreader or Vehicle Battery Kit
per the instructions included with the kit.
2. Install the vehicle harness included with the
spreader per the following instructions.
3. Install the cab control per the instructions included
with the cab control.
1. Plug the vehicle harness into the spreader harness.
2. Lay out a path for routing the vehicle harness into
the cab of the truck. Make sure the vehicle harness
avoids any hot or moving parts of the truck.
Routing will vary from truck to truck.
3. Identify a convenient location for the cab control
that can be reached by the harnesses and wiring.
4. Drill a 5/8" hole in the firewall so that the vehicle
harness can reach the desired cab control location.
5. Insert the rubber grommet into the hole.
6. Route the harness to the desired location.
7. Secure the vehicle harness to the truck. Verify that
the harness cannot drop onto the road when it is
disconnected from the spreader.
To Next Page
Loading...
