Lit. No. 94866/94867 5 June 1, 2002
SPREADER MOUNTING INSTRUCTIONS
Mounting the Spreader onto the Vehicle
1. Remove the tailgate from the truck.
2. Lift the spreader. See appropriate instructions
below.
NOTE: Periodically through the snow season,
verify the mounting devices are secure.
WARNING
Before lifting, verify hopper is empty of
material. The lifting device must be able to
support the spreader’s weight.
Regular Capacity: Lift spreader by hooking the loop
located on rear cross channel inside hopper.
NOTE: The loop is located at the approximate
balance point of the spreader. The balance point
may vary with engine fluid levels, battery, top
screen, or residual material in hopper.
High Capacity: Lift spreader by hooking all four loops
located at the corners of the hopper.
Loops
Lifting Loop
(Continued on next page.)
To Next Page
Loading...
