Lit. No. 94866/94867 7 June 1, 2002
CHUTE ATTACHMENT INSTRUCTIONS
Chute Assembly
1. Remove the conveyor guard from the engine
base.
2. Remove the shaft guard from the chute.
3. Remove the spinner coupling bolt and move the
spinner coupling slightly down the shaft.
3. Loosely attach the chute assembly using four
3/8" x 1" carriage bolts, flat washers, lock
washers, and nuts (supplied with the chute) with
the heads of the bolts on the inside of the chute.
4. Align the spinner shaft with the gearbox output
shaft. Once the shafts are aligned, move the
spinner coupling over both shafts and insert the
bolt and tighten the locknut.
5. Tighten the 3/8" nuts on the chute mounting bolts
according to the Torque Chart.
6. Replace the conveyor and shaft guards.
Shaft Guard
Spinner Coupling Bolt
Spinner Coupler
Chute Mounting Hardware
To Next Page
Loading...
