INSTRUCTION MANUAL FIT REMOTE DISPLAY PINION
10 TROUBLESHOOTING, FAULT CLEARANCE AND REPAIR
10.1 TROUBLESHOOTING AND FAULT CLEARANCE
10.1.1 DRIVE SYSTEM OR DISPLAY DOES NOT START UP
If the display and / or the drive system do not start up, proceed as follows:
1. Check if the battery is inserted correctly. If not, insert the battery correctly.
2. Start the drive system.
3. If the drive system does not start, remove the battery, check the charging status and charge if necessary.
4. Clean all contacts with a soft cloth.
5. Insert the battery.
6. Start the drive system.
7. If the drive system does not start, contact the specialist dealer.
NOTICE
If the battery terminal contacts are heavily soiled / oxidized. Take your e-bike to a specialist dealer
for a detailed check.
10.1.2 ERRORS IN THE ASSISTANCE SYSTEM
Symptom Cause Remedy
Assistance is not
available.
Is the speed too high? 1. Check display screen. The motor assistance is
only active up to the maximum speed for which
the e-bike is approved.
Is the battery charged sufficiently? 2. Check battery is charged.
3. Recharge the battery if it is almost flat.
The motor may become too hot
during rides at high temperatures,
up long inclines or when carrying a
heavy load for a long time.
4. Switch off the drive system.
5. Wait a moment and then check again.
The rechargeable battery, display
or operating element may be
connected incorrectly, or one or
more of them may have a problem.
6. Contact your specialist dealer.
Assistance is not
available.
Are the pedals being pushed? 1. Your e-bike is not a motorbike. Push the pedals.
Is the system switched on? 2. Press on-off button (operating element) to
switch on the system.
Is the level of assistance set to
OFF?
3. Set the level of assistance to FLY, FLEX, FLOW or
ECO.
4. Contact your specialist dealer if you still feel that
the no assistance is being supplied.
FIT_Manual_Remote_Display_Pinion_V3_en | Version 03 | 24.10.2023 51
To Next Page
Loading...