FiT REMOTE DISPLAY - Error Table

INSTRUCTION MANUAL FIT REMOTE DISPLAY PINION
8.3.1 ERROR TABLE
If the last two digits are listed with ”xx” as a placeholder, this provides the specialist dealer with additional information
for error analysis.
0A-xx up to 28-xx
Error code Error message displayed Action / Restriction
0A-01, 0B-01 Remote motor communication
error
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0A-02, 0B-02 Remote display communication
error
1. Restart the system.
2. Switch the system off.
3. Remove display from holder, check contacts and
clean if necessary.
4. Re-insert the display and start the system.
5. If the problem persists, please contact your
specialist dealer.
0A-03, 0A-04,
0A-05, 0A-06,
0B-03, 0B-04,
0B-05, 0B-06
Remote battery communication
error
1. Restart the system.
2. Switch the system off.
3. Remove the battery from the holder, check
contacts and clean if necessary.
4. Re-insert the battery and start the system.
5. If the problem persists, please contact your
specialist dealer.
0A-07, 0B-07 Remote speed node
communication error
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0A-08, 0B-08 Remote gears communication
error
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0A-0A, 0B-0A Remote charger communication
error
1. Restart the system.
2. Switch the system off.
3. Disconnect the charger from the system and
socket.
4. Wait until status LED goes out.
5. Check plug contacts on the e-bike and charger
and clean if necessary.
6. Reconnect the charger to the socket.
7. Reconnect the charger to the system and start
the system.
8. If the problem persists, please contact your
specialist dealer.
0A-0B, 0B-0B Remote lock communication error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0C-00 Remote identification error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0C-01 Remote motor identification error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
FIT_Manual_Remote_Display_Pinion_V3_en | Version 03 | 24.10.2023 34