FiT REMOTE DISPLAY - Page 35

INSTRUCTION MANUAL FIT REMOTE DISPLAY PINION
Error code Error message displayed Action / Restriction
0C-02 Remote display identification error 1. Restart the system.
2. Switch the system off.
3. Remove display from holder, check contacts and
clean if necessary.
4. Re-insert the display and start the system.
5. If the problem persists, please contact your
specialist dealer.
0C-03, 0C-04,
0C-05, 0C-06
Remote battery identification
error
1. Restart the system.
2. Switch the system off.
3. Remove the battery from the holder, check
contacts and clean if necessary.
4. Re-insert the battery and start the system.
5. If the problem persists, please contact your
specialist dealer.
0C-07 Remote speed node identification
error
1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0C-08 Remote gears identification error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0C-0A Remote charger identification
error
1. Restart the system.
2. Switch the system off.
3. Disconnect the charger from the system and
socket.
4. Wait until status LED goes out.
5. Check plug contacts on the e-bike and charger
and clean if necessary.
6. Reconnect the charger to the socket.
7. Reconnect the charger to the system and start
the system.
8. If the problem persists, please contact your
specialist dealer.
0C-0B Remote lock identification error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0D-01 Motor authentication error 1. Restart the system.
2. If the problem persists, please contact your
specialist dealer.
0D-02 Display authentication error 1. Restart the system.
2. Switch the system off.
3. Remove display from holder, check contacts and
clean if necessary.
4. Re-insert the display and start the system.
5. If the problem persists, please contact your
specialist dealer.
0D-03, 0D-04,
0D-05, 0D-06
Battery authentication error 1. Restart the system.
2. Switch the system off.
3. Remove the battery from the holder, check
contacts and clean if necessary.
4. Re-insert the battery and start the system.
5. If the problem persists, please contact your
specialist dealer.
FIT_Manual_Remote_Display_Pinion_V3_en | Version 03 | 24.10.2023 35