PowerFLARM Manual Version 1.0
Settings Menu
The settings menu is called up by extended fingertip pressure on
the button. The user then navigates his way through the menu by
turning the button. A short push on the button selects the item
that is currently displayed.
At the upper end of each menu, a push returns to the previous
level. At any level, the user may quit the menu by a long press of
the button.
Menu Diagram
The following diagram shows the PowerFLARM menu sequence.
Volume
Warning bleeper volume
Settings
Aircraft
Type: Selection of aircraft type
ICAO Address: Enter ICAO Address
XPDR: Own transponder details
FLARM
Range: FLARM-range
PCAS
Range: Horizontal range Transponder Receiver
Vertical Range: Vertical Range Transponder Receiver
ADS-B
Range: Horizontal Range ADS-B
Vertical Range: Vertical Range ADS-B
Data-Port
Baud Rate: Set data rate for RS232 data output
Sentences: Selection of data issued
Range: Horizontal Range of data issued
Brightness
Brightness Setting
Factory Reset
Return to factory settings
To Next Page
Loading...