Finder User Guide | www.flashforge.com 0086-0579-82273989
49
Method 2: Press the shortcut Ctrl+Z.
Redo
Allows users to redo the most recent edit you have undone to your model file by the
following two methods
Method 1: Click
[Edit]--[Redo]
Method 2: Press the shortcut
Ctrl+Y.
Empty Undo-stack
To clean up the recorded operating steps so as to release the memory.
Select All
By the following two methods, you could select all models in the scene. (When
models are too small to be seen or out of viewing scope, please click
[Center]and[Scale]buttons to adjust the model.)
Method 1: Click [Edit]--[Select All].
Method 2: Pressthe shortcut
Ctrl+A.
Duplicate
Select the object and duplicate the object through the following two methods:
Method 1: Click
[Edit]--[Duplicate]
Method 2: Press the shortcut
Ctrl+D
Delete
Select the object and delete the object through the following two methods:
Method 1: Click
[Edit]--[Delete]
Method 2: Press the shortcut
Delete
To Next Page
Loading...
