Finder User Guide | www.flashforge.com 0086-0579-82273989
62
transference, the printer will heat up automatically. And when heating finishes, the
printer will start to build the model.
If you want to print a Gcode from a local folder, you just need to load the file into
Flashprint at the status of USB connection or WIFI connection, then click the [Print]
button on the top-right.
Load the target Gcode file into FlashPrint.
7-9
Click the
[Print]button, the PC will transfer the Gcode file to the printer.
710
To Next Page
Loading...
