Finder User Guide | www.flashforge.com 0086-0579-82273989
63
After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.
7.2.3Print from USB Flash Disk
ķInsert your USB flash disk with target .g or .gx file to your Finder. .
ĸTurn on the Finder. Make sure the build plate has been leveled and the filament is
loaded.
ĹTap
[Print]and then tap the SD Card icon in the middle. The file(s) will be displayed
on the screen.Select the file you want to print and tap[Print]. The file will be
transferred to the printer.
ļAnd the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort
To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.
7-11
To Next Page
Loading...
