Flashforge Adventurer 4 Pro - Settings

6.3 Settings
The following functions are included in [Settings]: Move, Network, Fan, Language,
Status, Camera, Brightness, Light, FilamentDetect, Buzzer, PrinterName, About,
FactoryReset.
Move: To move the extruder left or right, (note that the noise is normal if it moves
past the farthest point of the left side), and to move the build plate back and forth,
(note that the noise is normal if it moves past the farthest point of the front side);
Network: To connect the device to the hotspot/Wi-Fi/FlashCloud/Polar Cloud;
Fan: To turn on/off the fan;
Language: To select the language;
Status: Including the device temperature, X/Y/Z position, etc.
21