Flashforge Adventurer 4 Pro - Maintain; Upgrade; Log

Brightness: To adjust the screen brightness;
Light: To turn on/off the light on the extruder;
FilamentDetect: To turn on/off the filament detection sensor;
This function is turned off by default. It is recommended to turn it on manually before
printing.
Buzzer: To turn on/off the boot sound and clicking sound.
PrinterName: Users can name the device;
About: Information of this device;
FactoryReset: To restore this device to factory settings.
6.4.1 Upgrade
When the device is connected to the network, it will be prompted to upgrade when the
new firmware is released;
6.4.2 Log
When the equipment has abnormal movements, the problem can be fed back to the
official after-sales team of Flashforge by copying the log.
6.4 Maintain
Maintain
Upgrade
Log
Calibration
ChangeExtruder
Maintain
22
Camera: Remote monitoring. Turn
on the [Camera] and [Time-lapse],
and the time-lapse video will be
recorded in the memory. It can be
found in [Pictures]. Choose [Take Pic],
and the live scene is saved as
images.