Creator 3 is equipped with independent dual extruders, which is suitable for PLA,ABS,PETG,Nylon（PA), PC, HIPS and
PVA. Independent dual extruder filament combination extrusion situations, see below:
Default left extruder as a support
Dissolvable filament: Insoluble filament combination：
Creator 3 is able to print PACF, , because of the material of the nozzle is not the hardened , the nozzle will be worn. It’s
estimated that printing 1-2kg of PACF, will need to change a new nozzle and have to equip with a strong extruder.
Standard device equipped with a standard feeding extruder.
Storage of PVA /PA
Direct exposure to the air, it is easy subject to moisture and softening, print bad easily after softening ,so please store
If using prepared models of Flashprint,setting completed automatically under the circumstance of choosing correct
Adaptability of filament parameters
28
Left extruder Right extruder
ASA
Left extruder Right extruder
ASA
ASA
To Next Page
Loading...
