Flashforge Creator 4 - Filament Configuration

21
5.4 Filament Configuration
Creator 4 series is equipped with two independent extruders;
Creator 4 series contains three types of extruders, which can support different
filaments separately.
Different types of equipment are equipped with different types of extruders:
Please refer to the table below for the combination of independent dual-extruder
extrusion filaments.
Creator 4F
Extruder-F
Suitable for printing
flexible filaments
TPU85A-95A
Creator 4A
Extruder-HT
Suitable for printing
engineering filaments
PLA/ABS/ASA/PETG/PC, etc.
Creator 4S
Extruder-HT/Extruder-HS
Suitable for printing
composite filaments
PACF/PAGF/PET-CF, etc.
Soluble filament combination: Insoluble filament combination:
Left extruder Right extruder
PVA
PVA
HIPS
HIPS
HIPS
HIPS
HIPS
PLA
NYLON
ABS
ASA
PC
PETG
HIPS
Left extruder Right extruder
PLA
ABS
ASA
PC
PA
PETG
PA-CF
PA-GF
PLA
ABS
ASA
PC
PA
PETG
PA-CF
PA-GF
PVA: Soluble in water.
HIPS: Soluble in limonene.
As carbon fiber or glass fiber material is with strong strength,
please use extruder-HS for printing this kind of material. The
extruder is configured with a 0.6mm-nozzle by default; Carbon
fiber composite materials are easy to cause blockage, so it is
not recommended to use a 0.4mm-nozzle for printing this.
Extruder-F
180-265℃
2.85mm
Extruder-HT
200-320℃
1.75mm
Extruder-HS
265-360℃
1.75mm
ATTENTION