Flashforge Creator 4 - Unpacking and Installation

07
1) To ensure the smooth transportation of the equipment,
please use an automatic or manual forklift with appropriate
specifications for handling.
2) Before unpacking, please make sure that the outer box of the
equipment is intact.
1. Use special tools to open the steel-edged wooden case;
2. Remove the steel-edged wooden case board and take off the protective foam;
3. Lift the equipment from the bottom of the wooden case;
4. Remove the protective wrapping film from the machine surface;
5. Open the front door of the machine and take out the power cord;
6. Connect the power cord to the socket and the equipment;
7. Touch the power switch slightly to start the machine;
1.2 Unpacking and Installation
Unpacking steps:
ATTENTION