Flashforge Hunter - About Hunter; 2.1 About Your Hunter

Clean and Remove the Model
2. Immerse the built plate and the print into
isopropyl alcohol (IPA), and rinse it thoroughly.
1. Fill the rinse bucket halfway with isopropyl
alcohol (IPA).
3. Once clean, place the build plate on a
clean surface and remove the print
product with a metal scraper.
Isopropyl Alcohol
(IP
A
)
For some prints that are difficult to remove,
use the plastic tweezers to detach the print
from the build plate grooves.
IPA is highly flammable!
The metal scraper is very sharp.
!
WARNING
!
WARNING
!
WARNING
10