FRET INFORMATION
To enable Customers to choose their own style of fret these fires are now available
without frets. In order to maintain the efficient and safe operation of the fire it is
important that any fret which is used must comply with the following dimensions.
(figure 51). It is important to clean a fret in accordance with the instructions
provided by your retailer as these vary depending on the surface finish of the fret.
Fig. 51
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a
registered gas installer. The part numbers of the replaceable parts are as follows,
these are available from your local stockist, whose details may be found on the
BFM Europe website, address as per rear page.
Complete pebble / ceramic set B-110000
Pebble fuelbed base B-108050
Pebble fuelbed front rail B-105060
Replacement pebble set B-110020
Complete coal / ceramic set B-121600
Coal fuelbed base B-121550
Coal fuelbed front rail B-121560
Replacement coal set B-121610
Glass panel B-125630
Piezo Igniter B-1320
Ignition wire manual models B-67910
Ignition wire remote models B-34690
NG manual gas valve B-102880
NG slide valve B-40980
NG RC gas control valve B-160780
RC handset B-168970
NG MC ODS pilot B-38930
NG SC ODS pilot B-49710
NG RC ODS pilot B-170240
54
Maximum
Height
210mm
Two Air Slots each of
Minimum Area 19cm2
Minimum Total Open
Area of Fret 110cm2
To Next Page
Loading...
Need help?
General
