Flavel Linear HE - Page 63

6.2.3 LIGHTING THE APPLIANCE - REMOTE CONTROL MODELS
(CONTINUED)
6.2.3.3 To decrease the heat input level of the burner hold the handset as
described in section 6.2.3.1 to unlock the keypad then press and
release the - button. Pressing and releasing the - button will lower the
heat input level one step at a time. Pressing the - button continuously
will move the heat input level to the minimum, see figure 4 below.
Fig. 4
6.2.3.4 To increase the heat input level of the fire’s burner hold the handset as
described in section 6.2.3.1 to unlock the keypad then press and
release the + button. Pressing and releasing the + button will increase
the heat input level one step at a time. Pressing the + button
continuously will move the heat input level to the maximum.
6.2.3.5 To turn the fire off hold the handset as described in section 6.2.3.1 to
unlock the keypad then press and release the power button. The
burner will go out.
62
“MIN FLAME”
displayed on
handset when
burner is
reduced to
minimum rate