Flex CS 60 WET - Page 26

CS 60 WET/CSW 4161
26
 Slowly feed the saw along the material.
 Feed the saw evenly through the material.
 If required, re-adjust the water supply.
 After cutting:
– Switch off the saw. Cutting-off wheel
continues running briefly!
– Turn off water supply.
 At the end of work:
Thoroughly clean the electric power tool
and accessories.
Guide rail
A guide rail (800 mm long) for the stone sepa-
rator is available from any FLEX-customer
service centre (order no. 353.280).
To extend the guide length, 2 guide rails
can be connected to each other.
To do this, a connector is available from
any FLEX customer service centre
(order no. 353.272).
Fitting the connector:
 Remove protective caps from the guide rails.
 Push connector halfway along the
guide rails.
 Clamp cams (4x).
“Sawing in” the guide rail:
klqb
_ÉÑçêÉ=ìëáåÖ=íÜÉ=ÖìáÇÉ=ê~áä=Ñçê=íÜÉ=Ñáêëí=íáãÉI=
Åìí íÜÉ=~åíáJëéäáåíÉê=ëÜçÉ=íç=íÜÉ=êÉèìáêÉÇ=ïáÇíÜK=
fí=áë=êÉÅçããÉåÇÉÇ=íç=ìëÉ=~=åÉï=Çá~ãçåÇJ
íáééÉÇ=ÅìííáåÖJçÑÑ=ïÜÉÉäK
 Set the mitre angle to 0° (CS 60 WET only).
 Set cutting depth to 15 mm (1.).
 Place guide rail on a stable, level support
ensuring that the anti-splinter shoe projects
at the front.
 Switch on saw.
 Place saw with the inner guide groove
on the guide rail (2.).