Flex CS 60 WET - Maintenance and Care

CS 60 WET/CSW 4161
27
 Feed saw evenly in the direction of the cut
as far as the end of the guide rail (3.).
Using the guide rail
klqb
tÜÉå=éä~ÅáåÖ=íÜÉ=ë~ï=çå=íÜÉ=ÖìáÇÉ=ê~áäI=~äï~óë=
ìëÉ=íÜÉ=ÖìáÇÉ=ÖêççîÉëK
Inner guide groove:
– CSW 4161
– CS 60 WET at mitre angle of 0°
Outer guide groove:
Only CS 60 WET at mitre angle set > 0°
Maintenance and care
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK=
Cleaning the electric power tool
t^okfkd>
aç=åçí=ìëÉ=ï~íÉê=çê=äáèìáÇ=ÇÉíÉêÖÉåíëK
 Regularly blow out the housing interior and
motor with dry compressed air.
 At the end of work immediately remove
abrasion-water mixture to prevent it from
drying and becoming encrusted.
 When changing the diamond-tipped
cutting-off wheel, clean the interior
of the guard hood.
 Also clean the guide rail, otherwise
the saw will not be guided properly
resulting in an inaccurate cut.