Angle grinder L3206C, L3208C, L4206C
19
6. Press and hold down the spindle lock
(7).
7. Tighten the clamping nut with the stop
key.
8. Insert the mains plug into the socket.
9. Switch on the angle grinder (without
locking into position) and leave the angle
grinder running for approx. 30 seconds.
Check for imbalances and vibrations.
10.Switch off the angle grinder.
Adjusting the switch handle
(only L3206C/L3208C)
The switch handle (11) can be rotated from
the middle position by 90°in either direction.
– Press the release button (1.) and
simultaneously rotate the switch
handle (2).
– Release the button.
Ensure that the release button
is engaged in the respective end
position.
Operating instructions
Note
When the angle grinder is switched off,
the grinding tool continues running briefly.
Rough-grinding
Danger!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be
no discoloration; nor will there be any
grooves.
Cut-off grinding
– Hazardous quartz dust is produced
when bricks, concrete and natural stone
are cut. For the sake of your health use
guards with the option of connecting
a dust extractor!
– Do not press, tilt or oscillate the angle
grinder.
– The angle grinder must always be
operated backwards, see diagram.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
Heft_5.book Seite 19 Mittwoch, 23. Februar 2005 4:15 16
To Next Page
Loading...
Need help?
General
