Flex L3206C User Manual

Angle grinder L3206C, L3208C, L4206C
20
– Adjust the feed to the material which
is to be cut:
the harder the material, the slower the
feed.
For further information on the
manufacturer’s products go to www.flex-
tools.de.
Maintenance and care
Danger!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Cleaning
Danger!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing.
Impairment of the protective insulation!
Operate the power tool via a residual-
current-operated circuit-breaker (tripping
current 30 mA).
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The angle grinder features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the angle grinder
switches off automatically.
Note!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the angle grinder is being used,
the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes spark excessively,
switch off the angle grinder immediately.
Take the angle grinder to a customer service
workshop authorised by the manufacturer.
Gears
Note!
Do not loosen the screws on the gear head
(5) during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Heft_5.book Seite 20 Mittwoch, 23. Februar 2005 4:15 16

Flex L3206C Specifications

General

Brand	Flex
Model	L3206C
Category	Grinder
Language	English