11 Advanced Measuring Functions FLUXUS F70x
UMFLUXUS_F7V4-6-2EN, 2017-10-01 111
11.11 Program Code
An ongoing measurement can be protected from an inadvertent intervention by means of a program code.
If a program code has been defined, it will be requested when there is an intervention in the measurement (key BRK).
11.11.1 Defining a Program Code
A program code will remain valid as long as:
• no other valid program code is entered or
• the program code is not deactivated.
11.11.2 Intervention in the Measurement
If a program code is active, the message PROGRAM CODE ACTIVE will be displayed for a few seconds when a key is
pressed.
To stop a measurement when it is protected by a program code, press key C and enter the program code. The display
does not change during the input of the program code. If the entered program code is correct, the measurement will be in-
terrupted and the main menu will be displayed.
The input of a program code is interrupted by pressing key C.
11.11.3 Deactivation of the Program Code
Select Special Funct.\Program code.
Enter a program code with max. 6 digits. Press ENTER.
An error message will be displayed if a reserved number has been entered (e.g., a Hot-
Code for language selection).
Note! Do not forget the program code!
Select Special Funct.\Program code.
The program code is deleted by entering "------". Press ENTER.
If the character "-" is entered less than six times, this character sequence will be used as
the new program code.
Special Funct. ↕
Program code
To Next Page
Loading...
Need help?
General
