FLIR Blackfly S - 5.7 General Purpose Input;Output (GPIO)

5 BlackflyS Physical Interface
Diagram Color
1
Pin Line Function Description Parameter Min Max Unit
Green 1
2
3
V
AUX
Auxiliary Input
Voltage (DC)
Input Voltage Range 8 24 V
GPI
Non-isolated
Input
Input Low Level 0 1.4 V
Input High Level 2.6 3.6 V
Propagation Delay 1 μs
Black 2 0 OPTOIN
Opto-isolated
Input
Input Low Level 0 1.4 V
Input High Level 2.6 30 V
Input Current 3.5 7 mA
Propagation Delay Low
to High
18 μs
Propagation Delay High
to Low
9 μs
Red 3
2
2
VOUT
Camera
Power Output
Output Voltage 3.05 3.35 V
Output Current 120 mA
GPIO
3
Non-isolated
Input/Ouput
Input Low Level 0 1.4 V
Input High Level 2.6 24 V
Propagation Delay 1 μs
Output Low Current 25 mA
Output High Level 0 24 V
White 4 1 OPTOOUT
3
Opto-isolated
Output
Output Low Current
4
25 mA
Output High Level 0 24 V
Propagation Delay Low
to High
36 μs
Propagation Delay High
to Low
18 μs
Blue 5 N/A Opto GND
Opto-isolated
Ground
Brown 6 N/A GND
Camera
Power Ground
Blackfly S Cased Models
Measurement conditions: Opto-Isolated I/O VCC=5V, Rext=1KOhm, Non-Isolated Output: VCC=5V, Rext=330 Ohm, Non-Isolated Input: VCC=3.3V.
Measured over operating temperature range (-20˚C to +50˚C ambient temperature), unless otherwise noted.
1—GPIO cable assembly wire colors
2—Dual function pin
3—Open drain output, requires pullup resistor
4—Output low level depends on the output voltage / pullup resistor combination
2/19/2019
©2015-2019 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
FLIR Blackfly
®
S Installation Guide 23