10
Camera Installation
Reattaching the Camera Module
3a. Reinsert ca
mera module into
camera base by aligning the arrow
notches on the edge of the camera
module and the camera base
(label on edge of camera module
indicates the location of the arrow
notch), and turning camera
module clockwise to lock into
place.
3b. Use the 3 base l
o
cking screws
to secure camera base to camera
module.
Go to step 4 to complete
inst
allation.
4.
Remove camera cover by
squeezing the back and front of
the co
ver (as indicated by the
arrow indicators) at the same
time and lifting it up and away
from the lens.
5.
Insert a video test cable into
the video test cable terminals
and co
nnect to a test monitor to
set up camera.
To Next Page
Loading...
