Quick start guide
11
11.1 Starting the camera for the first time
The first time you start the camera, you need to unlock the camera by entering a camera
unique code. The code is based on the serial number of the camera. To get the camera
unique code, you must log in with a FLIR Customer Support account and register the
camera. If you already have an existing FLIR Customer Support account, you can use
the same login credentials.
Follow this procedure:
1. Before operating the camera, you must read, understand, and follow the warnings,
cautions, and notes in sections , page and 5 Conditions of Use for Ex Equipment,
page 15.
2. Charge the battery for four hours, or until the green battery condition LED glows
continuously.
Note Do this at room temperature.
3. Put the battery into the battery compartment.
4. Insert a memory card into the card slot.
5. Close the cover and tighten the Torx T20 screw to 80 N cm.
6. Push the
button to turn on the camera. This displays the following dialog box:
Note When the camera is turned on, a mechanical cooler will begin cooling down
the infrared detector. The mechanical cooler has a sound that resembles a subdued
motor. This sound is normal. When the cooling procedure is completed, there is a
distinct change of the sound.
7. Use a computer or other device with internet access and go to the following website:
http://support.flir.com/unlock
This displays the following dialog:
#T810169; r. AN/42241/42268; en-US
23
To Next Page
Loading...
Need help?
General
