432-0012-01-10 Version 110 20
4
M500 System Configuration
Overview
This chapter describes how to configure the system options using on-screen-display (OSD)
menus. Operating the M500 camera does not require modifying any of the factory configuration
settings. However, the OSD menus allow setting the following:
• Choose configuration options that match personal preferences such as Joystick Mode or
default color scheme. Save the default configuration that will be active after a power cycle.
• Enable or disable specialized modes such as Tracker, InstAlert, IceAlert, NMEA messaging, or
operating the camera in Surveillance mode.
After making updates, most changes persist. However, a few settings revert to the factory default
when the system is rebooted. Refer to “Save current settings as start-up defaults:” on page 25.
Not all options can be used at the same time. The way the various options interact is also
described in the following sections.
Main Menu
Use the Menu button to turn the OSD menu on or off. When the OSD menu is shown, the joystick
is used to navigate through the menus and select various menu entries.
Use the joystick to navigate through the menus and select options.
Press the Menu button to exit the menus.
Note: During navigation in the OSD menu, camera zoom is
disabled, but manual focus/Auto focus is still enabled.
Figure 4-1: OSD Main Menu
Active menu item—Press right joystick button to select
Additional
End of menu symbol
Menu will loop to
the other end
menu items
To Next Page
Loading...
