FLIR MR160 - Moisture Display Modes Explained

FLIR MR160 USER MANUAL Document Identifier: MR160-en-US_AF
11
Fig. 5-1(a) IR + IGM Image Mode
5.2.2 Moisture Displays Overview
There are two modes where moisture readings are displayed; refer to Figs. 5-1 (a) and (b).
To access the modes, press the Select button after navigating to the Image Mode icon
in
the Main Menu. Then use the navigation buttons to scroll to the desired mode; press Select
again to confirm.
Fig. 5-1 (a) IR + IGM Moisture Image Mode
1. Relative icon and reference value
2. Alarm icon and Alarm Threshold value
3. Mode icon (pinless mode selected)
4. Moisture reading
5. Laser pointer icon
6. Cross-hairs
7. Thermal image
Fig. 5-1 (b) Moisture-only Mode
1. Moisture reading (digital)
2. Moisture reading (bargraph); Bars
are blue when in non-alarm state
and red when in an alarm state.
3. Selected Mode
4. High Moisture Alarm threshold (see
Section 5.7)
5. Set Reference value (see Set
Reference mode in Sections 5.2.3 and 5.2.6); pinless mode only. Note that in Pin mode this
display area will show the selected Material/Wood Group. Access the Moisture Mode to
select the Material/Wood Group.
Fig. 5-1(b) Moisture-only Mode