FLIR MR160 USER MANUAL Document Identifier: MR160-en-US_AF
7.3 Moisture Meter Specifications
Internal Pinless Sensor Measurements 0 to 100 (relative readings)
External Pin-based Measurements 7% - 30%* (±1.5% MC*)
30%-100%* (Reference Only)
Measurement Resolution 0.1
Pinless Measurement Depth 0.75” (1.9cm) maximum
Pin Moisture Groups Nine (9) material groups
Response time Pinless mode: 100ms
Pin mode: 750ms
Notes:
* Maximum specified range is dependent on the fiber saturation point for specific species. Beyond this point, the
reading can only be used as a relative reference value. For more information on fiber saturation please refer to
ASTM D7438. Accuracy specification is based on the analysis in J. Fernández-Golfín et al. Actual real-world
accuracy depends on a variety of factors; For more information, refer to ASTM D4444, section 6.
**Accuracy spec. applies to pin probe moisture measurements taken on wood whose temperature is 68°F
(20°C). Add 0.1% to the accuracy spec. for each °C below 20°C or subtract 0.1% for each °C above 20°C.
To Next Page
Loading...
