427-0075-01-12 Revision 140 October 2019 41
This document does not contain any export-controlled information.
Basic Operation and Configuration
Certificate information appears at the bottom of the TLS Config page, under Certificate
Information:
To enable and configure TLS:
Step 1 Under TLS Configuration, for Enabled, select
Yes.
Step 2 Select whether to redirect HTTP requests to
HTTPS.
Step 3 Click Save.
Step 4 Click Reboot. The camera reboots. After the camera reboots, TLS is enabled.
Server > Server Status
The page provides an indication of the current server status (either running or
stopped) and buttons for starting or stopping the server and for rebooting the system. The Uptime
section of the Server Status page shows how long the camera has been running, number of users,
and the load on the camera processor. All values are updated only when the Server Status page is
first accessed.
To Next Page
Loading...
