Fetching data from external FLIR
meters
17
17.1 General
You can fetch data from an external FLIR meter and merge this data into the result table
in the infrared image.
17.2 Supported FLIR meters
• FLIR CM78
• FLIR CM83
• FLIR DM93
• FLIR MR77
17.3 Technical support for external meters
Website
http://www.flir.com/test
Technical support
T&MSupport@flir.com
Repairs Repair@flir.com
Phone number +1 855-499-3662 (toll-free)
17.4 Typical moisture measurement and documentation procedure
17.4.1 General
The following procedure can form the basis for other procedures using FLIR meters and
infrared cameras.
Note
Before you can use a FLIR meter with the camera, you need to pair the devices. For more information,
see 11 Pairing Bluetooth devices, page 21.
17.4.2 Procedure
Follow this procedure:
1. Use the infrared camera to identify any potential damp areas behind walls and
ceilings.
2. Use the moisture meter to measure the moisture levels at various suspect locations
that may have been found.
3. When an area of particular interest is located, store the moisture reading in the mois-
ture meter’s memory and identify the measurement area with a handprint or other
thermal identifying marker.
4. Recall the reading from the meter memory. The moisture meter will now continuously
transmit this reading to the infrared camera.
5. Use the camera to take a thermal image of the area with the identifying marker. The
stored data from the moisture meter will also be saved on the image.
17.5 More information
For more information, see the users’ manuals that are shipped with the FLIR meters.
#T559880; r.15724/15724; en-US
47
To Next Page
Loading...
Need help?
General
