Operation
18
5.2 Menu sequence when starting up the device
The following menu sequence is displayed when the device is first started up, i.
e. is plugged into the mains or connected to a 24 V DC (12 V DC) supply:
Current software revisions and
device identification
Current time on therapy hour
meter (meter operates when
turbine is running).
Operating mode and readiness
display for device (operational
readiness)
If the device was switched off without ending the last treatment by pressing
the Start / Stop key, the next time it is switched on it will immediately start the
therapy again.
Every menu display can be "frozen" by pressing any key, i.e. the current
display will be held for as long as the key is pressed. If no key is pressed, each
menu is displayed for 3 seconds (serial number display 5 seconds).
To Next Page
Loading...