Flott TB 13 Plus - The Duties of the Operating Company; The Safety of the Machine

Safety Instructions
18 14/03/2023 212601
2.1.2 The Duties of the Operating Company
The operating company must take into account a number of obligations with
respect to its staff.
The operating company is obliged to
 Supplement the operating manual by instructions based on national regula-
tions for accident prevention and environmental protection
 Inform the staff of all relevant regulations, instructions and laws, where re-
quired
 Control all relevant regulations, notes and laws that will be complied with,
 Instruct the staff how to work on and with the machine
 Clearly define the responsibilities for operation, maintenance and repair of
the machine
 Check that the specified responsibilities are complied with
 Verify at regular intervals whether its staff is aware of potential hazards and
operates the machine in accordance with the safety standards laid down in
the operating manual and
 Ensure that the staff has read and understood the operating manual, espe-
cially the section on safety. If necessary, the operating company should
have the staff confirmed this in writing.
2.1.3 The Safety of the Machine
The following must be observed during all work on and with the machine:
 The applicable regulations
 The applicable professional association regulations (DGUV)
 The relevant provisions and applicable environmental laws
Only use the machine in a technically perfect condition. This means that all
safety equipment of the machine is present and functional. In case of malfunc-
tions or errors, you must immediately shut down the machine and notify the
person in charge of the operating company of this condition.
You may take the machine into operation after restoring the proper functioning
of the machine.
Do not dismantle or put out of operation any safety devices. If you still need to
dismantle the safety devices, e.g. during maintenance or servicing work, you
must install them again immediately after the work has been completed.
Check all safety devices for proper operation before operating the machine.
Note
Modifications, extensions and conversions of the machine that impair safety
are strictly prohibited. They require the written approval of Arnz FLOTT GmbH
Werkzeugmaschinen.
Only use original spare parts if you need to replace components of the ma-
chine. Operation and safety of the machine are preserved only with original
spare parts.