Introduction
212601 14/03/2023
9
1.1.3 Intended Use
The pillar drilling machine is designed exclusively for drilling, countersinking,
reaming and tapping metal, plastic and wood materials using suitable cutters.
The pillar drilling machine is intended to be operated by one person only.
Intended use also comprises
That the machine, depending on the type of machine, must be anchored to
the foundation or other suitable support
Compliance with the drilling performance stated in the technical data
That only appropriate spindles and cutters are used in their machine
That the cutters are properly fixed in the spindle
That the workpiece to be machined shall be secured against rotation on the
drilling table (e.g. by clamping or stop)
Compliance with inspection and maintenance schedules
That only FLOTT original spare parts are used and
Compliance with all instructions and information in this operating manual
and that of the spindles and cutters manufactures.
1.1.4 Improper Use
The pillar drilling machine must not be used for purposes other than as stated
in the section "Intended use". Any other use is considered improper.
Examples of improper use are
Drilling in other not suitable materials
The use of the machine without the necessary safety equipment
The use of unsuitable cutters and coolants
Unauthorized conversions or modifications to the machine.
Any improper use may result in:
Injury or killing of persons
Damage to the machine
Damage to other property.
Any improper use without exception is an action taken at the sole risk of the
user. Any resulting liability claims against Arnz FLOTT GmbH Werkzeug-
maschinen are excluded unless otherwise required by mandatory statutory
provisions.
To Next Page
Loading...
