Flowserve Limitorque L120-40 - Product Identification

7
Limitorque Actuation Systems L120 Series FCD LMENIM1201-04-A4 – 03/18
flowserve.com
2.3 Product Identification
The actuator unit nameplate is located on the back of the unit, opposite the limit switch compartment.
The nameplate contains the following information:
• Limitorque name
• Point of Manufacture
• Unit Size
• Order Number
• Serial Number
• Customer Tagging
• CE Stamp
The motor nameplate is located on the motor. The nameplate contains the following information:
• ID Number
• Start Torque
• Run Torque
• Enclosure Type
• RPM
• Volts
• Full Load Amps
• Locked Rotor Amps
• Insulation Class
• Duty
• Horsepower
• Service Factor
• Phase
• Cycles
• Motor Code
• Ambient Temperature
• Connection Diagram