3
Safety instruction
Read the safety instructions in this
manual carefully before using the product.
The installation, operation, and
maintenance of the product must be done
by staff with the necessary training and
experience.
PMV P3 basic unit
1. Introduction
The PMV P3 is a modular Positioner sys-
tem designed for use on control valves with
linear motion. The basic unit is the P3 posi-
tioner, which is available for single acting.
The I/P converter can be integral, located in
a separate mounted module (Ex), or located
elsewhere. The P3 can be equipped with
connection blocks for pressure gauges to
indicate:
- actuator pressure
- air supply pressure
- input signal pressure
PMV P3 with
explosion proof I/P
To Next Page
Loading...
Need help?
General
