5
GENERAL INFORMATION
INTRODUCTION
Before starting with any operation, it is necessary to have read the manual very carefully , as to avoid any problem
and/or mistaken usage of the machine, which could potentially be dangerous for the objects and the employees in
proximity. The operation and instruction manual is part of the technical leaflets supplied with the machine and the
aim is to give all the information necessary for a safe and correct use of the machine.
The manual is addressed to the people in charge of the installation of the machine, to the ones in charge of the use
and for the maintenance.
HOW TO READ THE MANUAL
During the consultation of this manual it is possible to see some symbols and the meaning of these symbols is
explained in the following table:
This type of signal advises the personnel about the
dangers during the operation of the machine. If the
notice is not followed and the fundamental
carefulness is not applied, the machine could
potentially put the employees in danger.
NOTICE OF DANGER
BECAUSE OF THE
PRESENCE OF ELECTRIC
TENSION ON THE
MACHINE
This type of notice informs about the presence of
tension. Before starting with regular/special
maintenance, it is necessary to stop the electric
tension by turning off the general switch. After
that it is necessary to be sure that tension is
totally absent.
This type of notice advises about the necessity to give
particular attention.
To Next Page
Loading...