106/107
Users Manual
4
• Do not use test leads if they are damaged. Examine the test leads for damaged
insulation and measure a known voltage.
• Do not apply more than the rated voltage, between the terminals or between
each terminal and earth ground.
• Do not use the HOLD function to measure unknown potentials. When HOLD is
turned on, the display does not change when a different potential is measured.
• Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.
• Keep fingers behind the finger guards on the probes.
• Remove all probes, test leads, and accessories before the battery door is
opened.
• Do not exceed the Measurement Category (CAT) rating of the lowest rated
individual component of a Product, probe, or accessory.
• Remove the input signals before you clean the Product.
• Have an approved technician repair the Product.
• Remove the batteries if the Product is not used for an extended period of time,
or if stored in temperatures above 50 °C. If the batteries are not removed,
battery leakage can damage the Product.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
