Digital Multimeters
Safety Information
5
• Replace the batteries when the low battery indicator shows to prevent
incorrect measurements.
• Use only specified replacement parts.
• Use only specified replacement fuses.
• Limit operation to the specified measurement category, voltage, or amperage
ratings.
• Do not use test leads if they are damaged. Examine the test leads for damaged
insulation and measure a known voltage.
• Do not use in CAT III or CAT IV environments without the protective cap
installed. The protective cap decreases the exposed probe metal to <4 mm.
This decreases the possibility of arc flash from short circuits.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
