Models 110, 111 & 112
Users Manual
ii
W Read Before Using the Meter: Warnings and Precautions
To avoid possible electric shock or personal injury, follow these guidelines:
• Use the Meter only as specified in this manual or the protection provided by the Meter might be impaired.
• Do not use the Meter or test leads if they appear damaged, or if the Meter is not operating properly.
• Always use proper terminals, switch position, and range for measurements.
• Verify the Meter's operation by measuring a known voltage. If in doubt, have the Meter serviced.
• Do not apply more than the rated voltage, as marked on Meter, between terminals or between any terminal and earth ground.
• Use caution with voltages above 30 V ac rms, 42 V ac peak, or 60 V dc. These voltages pose a shock hazard.
• To avoid false readings that can lead to electric shock and injury, replace the battery as soon as the low battery indicator (
N) appears.
• Disconnect circuit power and discharge all high-voltage capacitors before testing resistance, continuity, diodes, or capacitance.
• Do not use the Meter around explosive gas or vapor.
• When using test leads or probes, keep your fingers behind the finger guards.
• Remove test leads from Meter before opening the battery door or Meter case.
Symbols
B
AC (Alternating Current)
I
Fuse
F
DC (Direct Current)
P
Conforms to European Union directives
D
AC or DC
$
Canadian Standards Association
J
Earth ground
T
Double insulated
W
Important information; Refer to manual
t
950 Z Listed
Underwriters Laboratories, Inc.
N
Battery (Low battery when shown on display)
;
N10140
Conforms to relevant Australian standards
s
Inspected and licensed by TÜV Product Ser-
vices
#
VDE (Verband Deutscher Electroniker)
To Next Page
Loading...
Need help?
General
