1
Models 110, 111 & 112
True RMS Multimeters
The Fluke Model 110, Model 111, and Model 112 are battery-
powered, true-RMS multimeters (hereafter "the Meter") with a
6000-count display and a bar graph. This manual applies to all
three models. All figures show the Model 112.
The Meter measures or tests the following:
• AC / DC voltage and current
• Resistance
• Continuity
• Diodes
• Voltage and current frequency
• Capacitance
These meters meet CAT III IEC 61010-1-95 standards. The IEC
61010-1-95 safety standard defines four overvoltage categories
(CAT I to IV) based on the magnitude of danger from transient
impulses. CAT III meters are designed to protect against
transients in fixed-equipment installations at the distribution level.
Contacting Fluke
To contact Fluke, call:
USA: 1-888-99-FLUKE (1-888-993-5853)
Canada:1-800-36-FLUKE (1-800-363-5853)
Europe: +31 402-675-200
Japan: +81-3-3434-0181
Singapore +65-738-5655
Anywhere in the world: +1-425-446-5500
Visit Fluke's web site at: www.fluke.com
.
Register your Meter at: register.fluke.com
.
"Warning" and "Caution" Statements
A "WWarning" statement identifies hazardous conditions and
actions that could cause bodily harm or death.
A "Caution" statement identifies conditions and actions that could
damage the Meter or the equipment under test.
Unsafe Voltage
To alert you to the presence of a potentially hazardous voltage,
the
Y symbol is displayed when the Meter detects a voltage
≥ 30 V or a voltage overload (OL) condition.
Test Lead Alert
WWarning
Personal injury or damage to the Meter can occur if you
attempt to make a measurement with a lead in an
incorrect terminal.
To remind you to check that the test leads are in the correct
terminals,
LEAd
is displayed briefly when you move the rotary
switch to
or from any A position.
To Next Page
Loading...
