Fluke 123 Getting Started

1
Getting Started
Introduction
This Getting Started Manual provides basic information
on the Fluke 123 and 124 ScopeMeter Test Tools. For
complete operating instructions, refer to the Users
Manual on the accompanying CD-ROM
Contacting a Service Center
To locate a Fluke authorized service center, visit us on
the World Wide Web at: www.fluke.com
or call Fluke using any of the phone numbers listed
below:
+1-888-993-5853 in the U.S.A and Canada
+31-40-2675200 in Europe
+1-425-446-5500 from other countries.
Safety Information: Read First
The Fluke 123/124 ScopeMeter Test Tool (hereafter
referred to as “Test Tool”) complies with:
• ANSI/ISA S82.01-1994
• EN/IEC61010-1 (1993)
600 V Category III Installations, Pollution Degree 2
• CAN/CSA-C22.2 No.1010.1-92 (including approval)
• UL3111-1 (including approval)
Use the Test Tool only as specified in the Users Manual.
Otherwise, the protection provided by the Test Tool might
be impaired.
A Warning identifies conditions and actions that pose
hazard(s) to the user. A Caution identifies conditions and
actions that may damage the Test Tool.

Fluke 123 Specifications

General

Bandwidth	20 MHz
Sample Rate	25 MS/s
Channels	2
Input Impedance	1 MΩ
Display Size	5.7 inches
Temperature Range	0 °C to 50 °C
Dimensions	232 mm x 115 mm x 50 mm
Display	Digital LCD
Memory Depth	512 points per input
Battery Life	7 hours
Weight	1.2 kg
Safety Category	CAT III 600 V