Fluke 123/124
Getting Started
6
Making Menu Selections
Selection of a function in the menu is done as follows:
A menu pops up after operation of, for
instance, the SCOPE MENU key.
Use the arrow keys to highlight the
desired measurement function.
Press ENTER to confirm the selection.
Meter Measurements
Meter mode is used for OHMΩ, CONTinuity, DIODE, and
CAPacitance measurement. Use the Red Shielded Test
Lead at Input A and the Long Black Ground Lead at Input
COM (Common) in the way as shown in Figure 2.
100
Ω
Figure 2. Test lead arrangement for meter
measurements
To measure for instance a resistance, proceed as follows:
Open the INPUT A Menu.
Highlight OHMΩ.
Select Ohms measurement. The
resistance value is displayed in ohms.
Observe that also a bargraph is displayed
To Next Page
Loading...
