Power Logger
Safety Information
3
• Use Product-approved measurement
category (CAT), voltage, and amperage
rated accessories (probes, test leads, and
adapters) for all measurements.
• Do not use test leads if they are damaged.
Examine the test leads for damaged
insulation and measure a known voltage.
• Do not use the Product if it is damaged.
• The battery door must be closed and
locked before you operate the Product.
• Do not work alone.
• Use this Product indoors only.
• Do not use the Product around explosive
gas, vapor, or in damp or wet
environments.
• Use only the external mains power supply
included with the Product.
• Do not exceed the Measurement Category
(CAT) rating of the lowest rated individual
component of a Product, probe, or
accessory.
• Keep fingers behind the finger guards on
the probes.
• Do not use a current measurement as an
indication that a circuit is safe to touch. A
voltage measurement is necessary to know
if a circuit is hazardous.
• Do not touch voltages >30 V ac rms,
42 V ac peak, or 60 V dc.
• Do not apply more than the rated voltage,
between the terminals or between each
terminal and earth ground.
• Measure a known voltage first to make
sure that the Product operates correctly.
• De-energize the circuit or wear personal
protective equipment in compliance with
local requirements before you apply or
remove the flexible current probe.
• Remove all probes, test leads, and
accessories before the battery door is
opened.
• Do not use USB accessories when the
Product is installed in environment with
wires or exposed metal parts with
hazardous live voltage such as in cabinets.
• Do not operate the touch screen with sharp
objects
• Do not use the Product if the protection
film on the touch panel is damaged.
• Do not touch the metal parts of one test
lead when the other is still connected to
hazardous voltage.