Fluke 28 II Ex - Page 12

28 II Ex
Getting Started
4
WX Warning
To prevent personal injury in mining
hazardous areas:
• Avoid extreme mechanical burdens. The
Product can withstand impacts with an
energy of seven joules at -20 °C.
• Do not allow the Product to come in
permanent contact with oils, hydraulic
fluid, or grease.
• Do not install the Product in a fixed
installation.
WX Warning
To prevent possible electrical shock, fire, or
personal injury in ALL areas of operation:
• Read all safety Information before you
use the Product.
• Comply with local and national safety
codes. Use personal protective
equipment (approved rubber gloves, face
protection, and flame-resistant clothes)
to prevent shock and arc blast injury
where hazardous live conductors are
exposed
• See the “EX Safety Information” section
for additional warnings on Product use
in hazardous areas.
• Use the Product only as specified, or the
protection supplied by the Product can
be compromised.
• Do not use the Product in damp or wet
environments.
• Do not exceed the Measurement
Category (CAT) rating of the lowest rated
individual component of a Product,
probe, or accessory.
• Examine the case before you use the
Product. Look for cracks or missing
plastic. Carefully look at the insulation
around the terminals.
• Do not use test leads if they are
damaged. Examine the test leads for
damaged insulation, exposed metal, or if
the wear indicator shows. Check test
lead continuity.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.com