Fluke 28 II Ex Getting Started

28 II Ex
Getting Started
8
Table 1. Symbols

AC (Alternating Current)
J
Earth ground

DC (Direct Current)
I
Fuse
X
Hazardous voltage
P
Conforms to European Union directives.
W
Risk of Danger. Important information.
See Manual.
)
Conforms to relevant Canadian Standards
Association directives.

Battery. Low battery when displayed.
T
Double insulated
R
Continuity test or continuity beeper tone.

Capacitance
CAT III
IEC Overvoltage Category III
CAT III equipment is designed to protect
against transients in equipment in fixed-
equipment installations, such as
distribution panels, feeders and short
branch circuits, and lighting systems in
large buildings.
CAT IV
IEC Overvoltage Category IV
CAT IV equipment is designed to protect against
transients from the primary supply level, such as an
electricity Product or an overhead or underground
utility service.
(
Conforms to ATEX directive.

Conforms to relevant Australian standards.
®
Inspected and licensed by TÜV Product
Services.
Æ
Conforms to CAN/CSA-C22.2 No. 61010-1 2
nd
, +
Amendment 1.
~
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for recycling information.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.com

Fluke 28 II Ex Specifications

General

Diode test	Yes
Product type	Digital multimeter
Product color	Black, Red
Frequency range	0.0005 - 199.99 kHz
DC current range	0.0000001 - 10 A
DC voltage range	0.0001 - 1000 V
Resistance range	0.1 - 50000000 Ω
Measuring category	CAT IV 600V
Placement supported	Handheld multimeter
Basic accuracy (frequency)	0.005%
Basic accuracy (DC current)	0.2%
Basic accuracy (DC voltage)	0.05%
Temperature measurement range	-200 - 1090 °C
Battery type	AAA
Power source	Battery
Battery technology	Alkaline
Number of batteries supported	3
Operating altitude	0 - 2000 m
Maximum storage altitude	10000 m
Operating relative humidity (H-H)	0 - 80 %

Weight and Dimensions

Depth	198.1 mm
Width	100 mm
Height	6.35 mm
Weight	698.5 g