Fluke 3130 - Display Configuration Menu

3130
Users Manual
12
The main menu is shown in Figure 7 and has three levels.
hbb010.eps
Figure 9. Main Menu
• CONFIG (Configuration) - Push  to access the config menu. Push  again to go
to the Display Configuration menu. This will let you change the parameters for each
display section. See the Parameter Selection portion of the Figure 7.
• [Active Display] - See the “Top-Level Menu” section.
• MORE- Push  to access the % Error Main Menu.
Display Configuration Menu
Use the display configuration menu to set the parameters of the active display. Push the
SELECT softkey to move through this menu. See Figure 13.
hbb011.eps
Figure 10. Display Configuration Menu
The first parameter is Mode. Since voltage, current, and switch test modes all use the
same jacks, two of these functions cannot be used at the same time. What can be selected
depends on what is already selected in another display.
Push the NEXT softkey to change the second parameter. Pressure can be read in 14
different engineering units. Only Pressure mode has a second parameter.
These modes are available with a single display:
• P[1] = Pressure internal sensor
• [EXT] = Pressure with external pressure module
• P[1] ST = Switch Test with internal sensor
• [EXT] ST = Switch Test with external pressure module
Note
mA functions are only available on the lower section of the display.
• mA Measure = Milliamps measure.
• mA Source = Milliamps source.
• SIM-2W = Milliamps simulate using an external supply from the UUT.
• VOLTS = Voltage Measure.
• mA MEAS/24v
Table 2 shows which functions are available concurrently.
An X in a column indicates that the mode in the active display is not available for
selection if the mode in that row is in use in a different display.
Use the MORE option on the main menu to access other menu functions.